Stud finder tool is handy for Home Improvement
Image result for stud finder

For starting the process of improving and renovating your home, you need to have some essential tools like the stud finder tool. If you want to install a new chandelier for the ceiling and want to hang heavy artwork on the wall. You need to make sure that all the things are hung on a stud, so they are going to be secured and not fall. To find the place of the studs, you need to find the right and best stud finder tool. The best tool is the stud finder tool, which magnetically finds the studs. Some of the more straightforward methods to use these tools are listed below.

  • Firstly, make sure that the surface of the wall is clean and bright. If there is anything on the wall which is an obstruction, remove it first. After that, turn the stud finder tool on, hold it against the wall and press the button until the light flashes in the device or you hear a beep. This will calibrate the device. If you are doing this against a stud, it will not work, so you may have to end doing it again to make sure that it is correctly calibrated with the wall. This tells the device which parts of the fence is a wall, and which sections have a higher density and stud in between the walls.
  • Secondly, place the device flat with the wall, and start it around the area where you are going to be hanging something on the wall. You should move it slowly, in a horizontal direction, not vertical to get the best results. Make sure that you have pressed the button, or you will not get a flash or beep when you pass over a stud.
  • The device will beep or flash at the outer edge when you hit a stud and again at the other corner. These are the places you need to mark with a pencil, so you know where the studs are later on when you begin working. Then fix the nail on the stud as the last step.

0 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *